Protemp PT-05-240-GH User Manual download pdf (Page 5)

NEVER LEAVE HEATER

UNATTENDED WHILE

OPERATING

© 2012, Pinnacle Products International, Inc.

5

Electric Fan Heater User’s Manual

Safety Regulations (Continued)

- Please note that the fan heater can become

very hot and should, therefore, be placed

at a safe distance from flammable objects

such as furniture, curtains and similar

objects.

- NEVER suspend any objects from mounted

heater.

Assembly

Heater will operate on either 240 or 208 volts.

Check heater voltage and phase on label on

back of heater to make sure they are the same

as the electrical service supplied. See plug

configuration on page 2. Never use an adapter

for this blade configuration. The outlet must be

a 240 or 208 volt grounding outlet. When

properly installed, it will provide a ground

connection through the cord to the heater to

pretect the operator from electric shock.

Altering the cord in any way will void the

warranty.

Be sure that the electrical recepticle is of the

configuration and capacity appropriate fo rthe

heater. The ceiling mounting structure and

anchoring provisions must be of sufficient

strength to support the combined weight of the

heater and mounting bracket. Never suspend

any objects from the mounted heater.

1.Locate wood stud in ceiling where heater will

be mounted.

2.Use swivel bracket template to mark 4 holes

for drilling. Be sure a minimum of 2 holes

(across swivel bracket from each other) will be

drilled into wood stud in ceiling.

3.Pre-drill 4 holes for screws.

4.Attach swivel bracket to ceiling using 4 wash-

ers and screws (attach 2 screws to stud, then

turn 90 degrees to attach 2 final screws). 2

screws must be attached to a wood stud (min.

1.5"). If 2 remaining screws cannot be

attached to a wood stud, then moly / toggle

bolts should be used for 2 remaining holes.

Caution: If you are attaching this heater to a

ceiling surface other than a wood stud and dry-

wall, please use appropriate fasteners. the

screws included with your heater are not

intended to be used for metal studs. Do not

attach this heater to drywall only. Heater must

be attached to a stud with a minimum of 2

screws in opposing holes.

Operation

- Position the fan heater at a safe distance from

wet environments and flammable objects.

- Connect the fan heater to the electrical power.

- Set the thermostat dial to the maximum

temperature.

- The fan heater will switch on when the function

selector dial is set to one of the three power

settings.

- Once the room reaches the desired

temperature, turn the thermostat dial back until

heating element turns off. The fan will still

continue to run. The thermostat is now set at

your desired temperature, and the heater will

continue to maintain a constant temperature.

Cleaning and Maintenance

- Before cleaning the appliance, disconnect it

from the outlet and let it cool down.

- The enclosure is easy to get dirty. Wipe it often

with a soft sponge. For very dirty parts, wipe

with a sponge dipped in < 50°C water and

mild detergent, then dry the heater enclosure

with a clean cloth. Be careful not to let the

water enter the inside of the appliance

- In order to protect the enclosure

, don’t splash

water onto the heater, and never use a

solvent like

gasoline, isoamyl acetate, toluene,

etc. to clean the heater. Servicing should be

done only while the heater is disconnected

from the supply cord.

1 2 3 4 5 6 7 8 9 10 ... 17 18

Comments to this Manuals

No comments